Does Playing A Record At The Wrong Speed Damage It?

Does DJ scratching damage records?

Over time with excessive scratching, the stylus will cause what is referred to as “record burn” to a vinyl record..

What is better 33 or 45 rpm?

Vinyl records sound better if they are cut at higher speeds. The higher the rpm, the faster the vinyl passes under the playback stylus. This means that for each second of playback more sound information goes from the stylus to your speakers at 45rpm than 33rpm.

How do you know what speed your record is?

All records are measured and sorted by their RPM, which stands for revolutions per minute. This metric refers to how many times the platter, and therefore the record, will spin completely in one minute. There are only three speeds in which a vinyl record can be produced: 33 1/3 RPM.

How long is a 33 rpm record?

At 33 rpm they hold around 15-22 minutes per side. 33 rpm is the most common speed for 12 inch records.

Does playing a record backwards damage it?

Playing records backwards won’t damage the vinyl, but if your deck and stylus aren’t set up for it, you’ll damage them. … Because the needle is moving much faster in the groove it’s more likely to jump and skip, potentially scratching your records. Backwards is also dangerous. Most cartridges hold the needle at an angle.

What happens if you play a 45 record at 33?

If you play the record at 45 instead of at 33, that puts the frequencies recorded on the record 45/33 times as high, which means that as far as the record is concerned the effect of the stylus is what it would be if the resonance were at 13KHz while you played it at 33.

Who was the first person to scratch a record?

It was a protégé of Grandmaster Flash, the Grand Wizard Theodore, who created ‘scratching’ – the sound made when the record is rubbed back and forth. He discovered the technique by accident as he stopped the record with his hand to hear what his mother was shouting out to him.

How easy is it to scratch a record?

Dust (tiny rocks) on the floor are enough to scratch a record. Vinyl is a relatively soft material. Stacking bare records will also damage them, as dust will get between them, and if the records move, will scratch them. … Records can pick up tiny surface scratches from being slid in and out of the cardboard jacket.

What speed should a record player be?

Vinyl records come in three speeds: 33 1/3 rpm (often just called a “33”), 45 rpm and 78 rpm. The “rpm” is an abbreviation for “revolutions per minute” — an indication of how fast the record is meant to spin on the turntable.

Is it OK to touch vinyl?

Never touch the record’s playing surface with your bare hands or fingers as your body oil will transfer onto the record attracting even more dust thereby affecting sound quality. … If you accidentally touch a record, it is best to immediately clean it with a liquid record cleaner before putting it back in its sleeve.

Why do records play at 33 rpm?

The original acceptance of 33 1/3 by RCA in 1931 was a compromise between sound quality – the slower the rotation, the poorer the sounds quality – and quantity of recording time. The original microgroove could hold 23 minutes of recorded music. This was a huge increase from the 5 minutes per side of the 78.

What is the difference between a 33 and a 45 record?

33 RPM will generally lead to more playtime fitting on a record side. Going with 45 RPM will generally lead to playtime and low production costs being sacrificed for more audio quality. This is due to the fact that a higher speed allows the recording to fit more sound information in each second.

Can all record players play 7 inch?

All record players do not play every single size of vinyl record. All record players will play the two most common sizes of vinyl record, those being 12-inch and 7-inch, but it is far less likely they will be able to play a 10-inch record.

Does playing a record damage it?

As for wear-induced noise, most of that comes from playing records with a worn-out or damaged stylus (aka needle) that’s literally gouging the grooves with each play. Any decent cartridge will play records without damaging the groove. … A force setting that’s too high or too low can accelerate record wear and noise.

What is cue burn?

Cue Burn. Definition : Cue Burn is a phenomenon which occured when DJs used vinyl recordings ( 33 rpm , 45 rpm ) to play songs .